Stone honeycomb panel is Italian cutting equipment and technology introduced by CEC. It cuts natural granite and marble into 3-5mm thick slices, and then uses French aviation composite technology to combine them with aluminum honeycomb to produce high-tech products.
The ultra-thin stone honeycomb panel maintains the beauty of natural stone, and overcomes the shortcomings of natural stone, such as brittleness, brittleness, and heavy weight. Due to the addition of high-quality aluminum plate as a transition layer between the stone sheet and the aluminum honeycomb, the product has stronger impact resistance and flexural strength.
This product has reached the international leading level and filled the domestic blank, and is widely used in building curtain wall and indoor and outdoor decoration. It is one of the most advanced green environmental protection materials in the world. The green, environmental protection and natural decorative effect of stone has always been favored by architects at home and abroad. However, due to its shortcomings such as heavy weight and easy breakage, it has always plagued users in terms of safety, and it has also affected natural stone. widespread popularity. However, natural stone is restricted by its inherent brittleness, and in general, the thickness cannot be reduced indefinitely. Therefore, currently, conventional equipment can only cut out the thinnest 8-9mm plate.
Characteristics of stone honeycomb panels
1. Light weight: The thinnest marble composite panel can be only 5mm thick (compounded with aluminum honeycomb panel). Commonly used composite tiles or granite are only about 12mm thick, which saves a lot of cost in transportation. It is the best choice when there are load restrictions on the building.
2. Strength improvement: After the marble is combined with ceramic tiles, granite, aluminum honeycomb panels, etc., its bending, bending and shearing strengths are significantly improved, which greatly reduces the damage rate during transportation, installation and use.
3. Improve the anti-pollution ability: Ordinary marble slabs (full-body slabs) are likely to have various discolorations and stains on the marble surface after half a year or a year, which are very difficult to remove during installation or later use, such as wet paste with cement. The composite board avoids this because of its harder and denser bottom plate and a thin layer of glue.
4. It is easier to control the color difference: Because the marble composite board is cut into 3 or 4 pieces with 1m2 original board (full body board), it becomes 3m2 or 4m2. The pattern and color of these 3 and 4m2 are almost 100 percent the same, so it is easier to ensure the consistency of color and pattern when used in a large area.
5. Easy to install: Due to the above characteristics, during the installation process, regardless of weight, fragile (strength, etc.) or color separation splicing, the installation efficiency and safety are greatly improved, and the installation cost is also reduced.
